ESPixelStick V3 COM...
 
Notifications
Clear all

ESPixelStick V3 COM Port Fail

9 Posts
5 Users
1 Reactions
598 Views
MichiganLights
Posts: 479
Topic starter
(@michiganlights)
Prominent Member
Joined: 14 years ago
[#58897]

I have a ESPixelstick V3 I'm trying to update firmware with the ESPSFlashTool. I get a "Failed to open serial port COM3" I tried a second board and get the same issue.

According to Device Manger the port is working properly. When I plug in the ESPixelstick com3 opens with the CH340 driver. The flash tool just doesn't.

ESPixelStick

If a board is not in program mode does the com port fail? I jumper Gnd and D3 then hit reset to enter program mode. Do I have that correct?

Any ideas? is there a low level ping or other command to send to the board?


8 Replies
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

Are you accessing com3 from another program or screen?


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Your OS may need updating .


Reply
MichiganLights
Posts: 479
Topic starter
(@michiganlights)
Prominent Member
Joined: 14 years ago
MikeKrebs wrote:
Are you accessing com3 from another program or screen?

Not that is obvious.

Along those lines what baud, bits and stop should the USB port be configured? I don't recall ever setting this. Does it matter?

I loaded some firmware this past spring without issue 🙁


Reply
MichiganLights
Posts: 479
Topic starter
(@michiganlights)
Prominent Member
Joined: 14 years ago
angus40 wrote:
Your OS may need updating .

Auto Update is on. Is there anything specific, for example an optional update that may not be loading?


Reply
Page 1 / 2
Share: