ESPixelStick Setup ...
 
Notifications
Clear all

ESPixelStick Setup Check

7 Posts
3 Users
0 Reactions
1,208 Views
MichiganLights
Posts: 479
Topic starter
(@michiganlights)
Prominent Member
Joined: 14 years ago
[#57335]

I have 10 custom props, 16 pixels each (160 total) on a dedicated ESPixelstick.

All props are turning on solid, the same color even though The Vixen3 data stream is constantly changing colors running a chase. So while trouble shooting, I disconnected the 4th prop in the string and 1st 3 ran the sequence correctly. I plugged the remainder of the string in and now it all works.

I have two ESPixelSticks in my display.

1) E1.31/Renard, static IP 10.0.2.101
2) E1.31/WS2811, static IP 10.0.2.103

Both controllers are running Multicast Ethernet.

Do these settings look reasonable? What is the "group" setting for?

This is my first run at pixels so any pointers are appreciated.

ESPixelStick 03 01

6 Replies
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Most likely you need to add some power injection.


Reply
Posts: 304
(@dennis-cherry)
Reputable Member
Joined: 19 years ago

You might want to reduce the brightness intensity to 40% or less.

Dennis


Reply
MichiganLights
Posts: 479
Topic starter
(@michiganlights)
Prominent Member
Joined: 14 years ago
MartinMueller2003 wrote:Most likely you need to add some power injection.

I was hoping to avoid the need, I made sure the PSU had plenty of capacity. The total DC line is 50ft of #18AWG. What would be an acceptable voltage drop for 12V pixels?

Dennis Cherry wrote:You might want to reduce the brightness intensity to 40% or less.
Dennis

I will definitely update the sequences along these lines.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

18awg I keep those runs under 10'
16awg I will go to 20'
Further than that and I add a PSU closer to the prop.
2v drop on 12v line is ok. More than that and things can start to pink out on you.


Reply
Page 1 / 2
Share: