So did you just block the FPP on the wifi network? I am trying to get all mine working and am running into some problems with lag and range with my Ubiquiti Unifi AP. Or do you turn off the wifi in the fpp settings?
Hmmmm.... I'm not completely sure how well the Unifi AP handles multicast traffic.... I vaguely recall reading something about it that it wasn't very efficient, but I can't recall exactly....
ScareCrowe wrote:Update on my issue.I switched to multicast and still had issues. Tried a different ESP and couldn't get it to work at all. Went to flash it again and realized didn't have the tool so re-downloaded and flashed. When it booted up it looked different and then I realized I had been using version 2 instead of 3! grrrr...... What ever my issue was before is gone now. Flashed all my ESPs to v3 and viola! (I blame the blinky flashies for my brain deficiencies)
If you guys are running v2 like me, upgrade! Here is the link, I did the 3rd from the bottom:
https://github.com/forkineye/ESPixelStick/releases
Hopefully this will help you guys too.
This is the third one down. Is this the one you are referring to?
I got it all working mostly without lag using multicast. I had 2 aps setup and they were conflicting. Took one down and all is well. I think I need to set them up as mesh, instead of both stand alone.
11Bravo wrote:This is the third one down. Is this the one you are referring to?
Nope, that is third from the top actually. I did the third from the bottom. It is titled "ESPixelStick v3.0 Firmware" and shows as the 'latest release' in green to the left of it.
Thank you for the clarification, sorry I miss read your post. I was thinking third one down instead of third up from the bottom.
JLStout wrote:I got it all working mostly without lag using multicast. I had 2 aps setup and they were conflicting. Took one down and all is well. I think I need to set them up as mesh, instead of both stand alone.
Don't use mesh, will cause all sorts of lag and wreak havoc. If you really need to use 2 AP's, give them different SSIDs and assign the sticks to each one manually or else they may bounce around and roam.
Thanks Sporadic, that is good to know. I thought about doing it the way you suggested as well.
I am having similar issues. I have 13 pixel sticks deployed throughout my yard. (All within 100yds of the AP on my front porch.) The AP is a Bullet M2 High Power into a 18db gain vertical antenna. (I just swapped a regular M2HP for a Titanium version with no difference in performance.) [BTW: I have a small wireless ISP, so wireless equipment is not an issue.]
I sometimes see ping times and latency figures on the bullet of 2000ms or more. Then, for no good reason, pings come back down in the 2-100ms frame. Then, again, they go back up into the 2s area. There doesn't seem to be any "in-between" it's either "bad" or "good".
Is there a "known good" setup or set of screen shots for setting up a Ubiquity device for best performance?
I have attached a few screen shots of my config for you guys to look over and see if there are any glaring issues.
The firmware on the bullet is the latest and greatest - Firmware Version: XM.v6.1.8
The firmware on the PixelSticks is 3.1-dev dates 8/4/18
I admittedly have NOT tried any other AP, but I figure a Bullet M2HP Titanium *should* be about as good as it gets, not?
Pic 3, why MCS 3 for max Tx rate



