That's definitely a potential problem causer but I doubt that relates to what I experiencing. I don't know about little_b, but my display and home network are physically separate. My home net is entirely hard wired, the home router is upstairs (only phones are wireless) and the display router is roughly 28" from the ESP. I've experienced the same thing with the ESPs since I got them months ago and have been troubleshooting it using every configuration I can think of. I just can't figure it out!
Switch it to multicast and turn off any "multicast enhancement" if there is that option on your router.
If you have any sequence errors at all when using unicast, that's a sign that you have interference or poor reception. Unicast traffic will retry many time until it finally gets there. So if you see a sequence error, that means it's failed on several successive attempts and finally gave up. That's where your lag comes from, the retrying packets.
When using sACN over wifi, you really should be using multicast. Unicast can work in ideal conditions, with a few universes, but it's not going to scale well and it's not going to handle interference and poor reception very well.
ScareCrowe, if you really mean 28", that could be an issue too. Closer isn't always better, I've seen WiFi radios respond poorly when the signal is too strong. 6-10' should be a minimum.
I actually started with multicast and thought that the protocol might be the culprit. My thinking was maybe if the same broadcast was hitting every controller the same maybe it was collision issues or something. I switched to Unicast thinking perhaps with traffic being specifically directed to an IP that would help filter traffic with the result being less lag or loss.
I normally don't have the router that close to the controller. I just put everything on my workbench to film the video and only mentioned it because having it that close means the router signal should be more than powerful enough to not suffer outside interference.
The sACN Priority setting... I didn't set or modify that. It was the only non-zero value shown on the controllers ACN configuration panel so I had included it in my notes. Should I change the value to something else?
I'll switch back to Multicast and fiddle around with it. There has to be something there I missed.
Thanks for the responses everyone. My network is separate from my home as well. I am running my pixels on an E1.31 network. Cat5e runs from laptop to router then out to a couple switches then to all my other pixel controllers in the yard. My ESPixelSticks are on Unicast along with the rest of my Pixel Controllers. I haven't tried Multicast before, but is it possible to run the ESPixelStcks on Multicast and the rest on Unicast?
