Espixelstick help
 
Notifications
Clear all

Espixelstick help

11 Posts
5 Users
0 Reactions
4,665 Views
Posts: 21
Topic starter
(@pmjr778)
Eminent Member
Joined: 6 years ago
[#54024]

I have an espixelstick that I am trying to use in xlights. I am able to get the lights to work in test mode through xlights but when I create a single strand of 50 nodes in layout and attempt to get it to work in sequence. I get nothing. I should also mention that if I click on the light bulb, they don’t work. Being a newbie any help would be great. Thank you


10 Replies
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

To build off of what Mike suggested. When you test from XLights are you testing All Channels or the specific channels you have assigned to this string? It sounds like the channels you have assigned to the model do not match the channels assigned in your setup.


Reply
Posts: 21
Topic starter
(@pmjr778)
Eminent Member
Joined: 6 years ago

Thanks for you help. I have to be honest, I am not sure what I am doing. To test the controller I am using an LED strip, 60 LEDS/m, 1 chip per 3 LEDs. Here are screen shots.

setup
setup2

Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

set the Start Channel on your Model to "1" instead of !FirstPixelStick:1. If you added a 2nd model, you could then set that Start Channel to ">Single Line"


Reply
Posts: 21
Topic starter
(@pmjr778)
Eminent Member
Joined: 6 years ago

Still no success. Works with Test and I can check all the channels. Everything works with espixlstick programmer. But I can get it to do anything with a sequence or by hitting the light bulb.


Reply
Page 1 / 3
Share: