ESPixelStick Flash ...
 
Notifications
Clear all

ESPixelStick Flash Tool

223 Posts
49 Users
0 Reactions
100.3 K Views
Posts: 3
(@rockendoublez)
New Member
Joined: 9 years ago

yes i flipped the rx and tx. verified by hitting the reset button and got gibberish in the serial output window. q=\


Reply
Posts: 3
(@rockendoublez)
New Member
Joined: 9 years ago
sporadic wrote:Looks like you're not putting it into program mode. Make sure you hold down PROG, click RESET, then release PROG.
-shelby

I guess i'm having one hell of a time getting it into program mode. I've done the hold down PROG, click RESET, then release PROG. a bunch of times in different ways. LOL still no joy.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

That's happens to me when they are not flashed, or incomplete flash.

I concur with Shelby comment below....appears the button pushing sequence isn't putting the ESP into programming mode.

Try again with these steps. No need to rush between steps - take your time.
Maybe twice again - may need to flip TX & RX the second try.

Connect CP2102 and cable to ESPixelStick
Connect power to ESPixelStick
Start ESPFlashtool
Press and hold BOTH buttons on ESPixelStick
Release the reset button
Pause
Release the reset button <== Edit: This should be release the program button
Click UPLOAD
Watch the process - takes a couple minutes, and appears to load twice. It should eventually give you the IP Address in the serial output

Edit: I guess it could be a faulty programmer.


Reply
Posts: 555
(@zaker)
Honorable Member
Joined: 19 years ago

I'm having the same problem programming also. I have followed the sequence, hit UPLOAD, programming fails. Tried with 3 different ESP modules, 2 are from Shelby when I bought the ESPixelSticks

If I hit reset in the Pixelstick, I see the AI-Thinker message sent from the ESP through the programmer, so the RX & TX are correct. When it is trying to program, I do see the blue light blink on the ESP board. Any other suggestions?? I did use this programmer before when I programmed an ESP, so it did work. But is was last year. How can I check if I have a fake FTDI chip? I assumed the input and output would be blocked if ti was a fake.

I TRIPLE checked the RX & TX, but not the GND!! there were two pins labelled GND, but one actually wasn't. Flipped th eprogramer over and noticed one was connected to the ground plane, moved it, programming away!


Reply
Posts: 360
(@jlstout)
Reputable Member
Joined: 16 years ago

I can't seem to open the flash tool. Using version 3.0. I have used it to program multiple sticks, but when I try to open the .jar file, nothing happens. Re-installed java with no effect. Rebooted computer multiple times. Not sure what is going on with this.


Reply
Page 44 / 45
Share: