ESPixelstick 4.0-be...
 
Notifications
Clear all

ESPixelstick 4.0-beta5 DMX

23 Posts
2 Users
1 Reactions
3,414 Views
Posts: 89
Topic starter
(@rreese)
Estimable Member
Joined: 5 years ago
[#58225]

Is there any documentation on how to wire and configure the ESPixelstick for DMX?


22 Replies
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

It depends.

ESPS V3 base card has the D+ and D- outputs already set up for you. If you are using any other base platform, you will need to add a 3.3v TTL to RS-485 level shifter to get the desired differential outputs. Both ESPS V3 and ESPS V4 SW support the ESPS V3 base card DMX output. ESPS V4 SW extends support to 20+ additional platforms, turning most any pixel output into an RS-485 TTL output.


Reply
Posts: 89
Topic starter
(@rreese)
Estimable Member
Joined: 5 years ago

Thanks for the info.
I am using Xlights.
If I place my moving head on Pixel Port 1, then XLights does an FPP connect and Upload Outputs correctly.
If I place the moving head on Serial Port 1, FPP connect works, but fails to Upload Outputs.
Is this an issue with what I am trying to do or an issue with XLIghts?

PixelStick 02
PixelStick 01
PixelStick 01
PixelStick 02
PixelStick 03
PixelStick 04
PixelStick 05
PixelStick 06

Reply
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

it is an xlights issue


Reply
Posts: 89
Topic starter
(@rreese)
Estimable Member
Joined: 5 years ago

Thank you...


Reply
Posts: 89
Topic starter
(@rreese)
Estimable Member
Joined: 5 years ago

I am using the ForkInEye ESPixelStick V3
I have made the correct cable using the D+, D-, and V- to the proper pinouts on the DMX connector.
I have manually set the Pixelstick to DMX and uploaded a simple fscq file for my moving head.
No matter the configuration

Stick

I try, the moving head does not respond.


Reply
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

what do you see on the diagnostics screen


Reply
Posts: 89
Topic starter
(@rreese)
Estimable Member
Joined: 5 years ago

Nothing happens.
I have a second stick with pixels and that does show activity so I do know to look at the diag screen.


Reply
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

then you have an error in the fseq file. what is on the status screen?


Reply
Posts: 89
Topic starter
(@rreese)
Estimable Member
Joined: 5 years ago

The status screen looks good and shows the fseq playing.
Interesting note. When I tried to run the sequence from XLights, nothing worked.
When I am connected to a different controller and playing the same file, everything works.


Reply
Page 1 / 3
Share: