ESPixel GECE Info T...
 
Notifications
Clear all

ESPixel GECE Info Thread

123 Posts
28 Users
0 Reactions
51.4 K Views
Posts: 691
(@stormyblade)
Honorable Member
Joined: 12 years ago
Flyrockets wrote:Finally got my boards, really was working on next year but with the weather I just might get some out! Just soldered and tested 10. Now to yank stuff on lawn and install! Bill, again, fantastic job on designing this!

1 set of 10 boards arrived today in the mail! I just soldered up 1 board for testing - I might have to send you a message or two asking how to get these things set up.


Reply
Posts: 503
(@iflights)
Honorable Member
Joined: 14 years ago
AuburnLights wrote:Good point

And you will want to confirm that the stock power supply you use will be enough to power a string longer than the original 50. You'll want to be considering voltage drop on the last ones in the now longer string.


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

The stock supplies all look the same but have different ratings. So be careful.


Reply
Posts: 7
(@jonchilds)
Active Member
Joined: 15 years ago
iflights wrote:And you will want to confirm that the stock power supply you use will be enough to power a string longer than the original 50. You'll want to be considering voltage drop on the last ones in the now longer string.

Is there any info around about the power requirements say per bulb? For instance you will want to be able to supply 20 millamps per bulb.

Thanks
Jon


Reply
Posts: 911
Topic starter
(@madsci1016)
Noble Member
Joined: 12 years ago

Most any type of pixels in general draw 50 to 60 MA at worst case, which is full white.

Sent from my Nexus 5X using Tapatalk


Reply
Page 16 / 25
Share: