2nd year newbie here also and could use some help. I also have a e682 to which I used last year on a bunch of arch's. They worked great. This year I'm adding to my display and I'm doing a 180 degree 16' pixel tree. I purchased a new Falcon 16v3, but before I received the new board I was using the E682 to test and burn the new pixels in for the tree and I had the same problem with the new pixels not working and the firmware update also solved my problem. The down side is after the firmware update my arch's do not work any more. The pixels work fine, but the arch's are dead. They either go all white or do not show anything at all. To add to the confusion, I can plug the arch's into my Falcon16v3 controller and they work fine. All I do is unplug from the E682 and plug them into the Falcon and boom they work. I have no Idea what the deal is makes no sense to me.
Recap
New pixels work fine on SanDevice, arch's do not 🙁
New pixels work fine on Falcon 16v3 controller and the arch's do also?
Here is the
Mokungit 16.4ft 5M DC12V WS2811 20 Pixels 60 LEDs/M 5050 RGB SMD LED Digital Dream Color LED Strip
Just FYI to all: I ended up getting it. If you change the pixel timing to 300ms they work fine. :thup2:
hi all I'm a newbie and I'm totally confused. I hope some one here can help me.
first question. how do I upgrade firmware on my e682?
second question. how do I change pixel timing?
third. I bought new technicolor pixels from ray wu and none of them are coming on when I plug the in to my e682 controller.
TIA
remember I'm a newbie and trying to get something going. thanks
thanks angus40
