What value resistor networks are folks using to get 20 foot cable runs? I just got in my pre-made Ray Wu cables. The 10 foot cables work but the 20 do not. Getting power and ground and the cables ohm out good so thinking it is an issue pushing the data. Before I cut all my nice new cables and install null pixels what change to the resistor networks might work?
As always thinks in advance for the help!
Rich
Sent from my iPhone using Tapatalk
I used these and they really helped with flickering. Don't know if they will go 20 ft. but it's worth a try.
http://www.ebay.com/itm/111333097879?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
John
I got in the group buy for Buffer/Line driver. Ordered 35. Replaces null pixels without having to add the null pixel in your sequencing software or controller setup.
Sent from my SM-T710 using Tapatalk
I have used cat5 for my cabling to some arches. The longest run is about 30'; I have not had problems with this config the last few years. Using the "stock" E682 resistors...
jcmarksafb wrote:I used these and they really helped with flickering. Don't know if they will go 20 ft. but it's worth a try.
http://www.ebay.com/itm/111333097879?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
John
John if you got a 100 of them, why don't you sell a few to us other E682 guys for like 8 at $2.50 + shipping and we all benefit and you can de-junk a little!
Alan
