Notifications
Clear all

E682 Problem

11 Posts
4 Users
0 Reactions
3,320 Views
Posts: 347
Topic starter
(@dougd)
Reputable Member
Joined: 19 years ago

Not familiar with resetting the board. How is it done?


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

Press and hold reset button until all the light go out. Also check all your fuses. Can you post a pic of your board?


Reply
Posts: 347
Topic starter
(@dougd)
Reputable Member
Joined: 19 years ago

Reset didn't help. I will post some pictures.


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago
dougd wrote:Reset didn't help. I will post some pictures.

So, let me get this straight...you can't get to the HTML screen for the 682?


Reply
Posts: 1249
(@jstjohnz)
Noble Member
Joined: 17 years ago

Does the board run pixels? Can you ping the IP address of the controller? Watch the LEDs on the Ethernet module as you power up. You should see some activity on the LEDs, then off for about a second, then on again. What IP reads out when you do override 1?


Reply
Page 2 / 3
Share: