Notifications
Clear all

E682 Problem

11 Posts
4 Users
0 Reactions
3,317 Views
Posts: 347
Topic starter
(@dougd)
Reputable Member
Joined: 19 years ago
[#31802]

During the Christmas season last year I had a box that drew in a bit of moisture (condensation). Unfortunately my 682 was sitting in the small bit of condensation and quit working. Fortunately I had a spare and put the spare out in the display.

I sprayed contact cleaner on the bad board and besides a bit of haziness on the board it started working, I was thinking no harm no foul. I have been using that board as my test board when testing pixels this year. I turned the board on a few days ago and it is not working again. Not working as in I can not talk to it via a web page.

The board itself appears to be working fine. The programs mode 1 tells me the ip number.

Any ideas on how to trouble shoot this?

Thanks
Doug


10 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

I would half-lift out all the socketed chips and push them back in a couple times to work those connections. You might want to indicate the status of the LEDs and also do some basic voltage measurements of the rails.


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

I would check the rj45 socket. Lift it off the headers and make sure it's dry maybe dip in 90% isopropyl alcohol.


Reply
Posts: 347
Topic starter
(@dougd)
Reputable Member
Joined: 19 years ago

The status of the LED's is "normal" red is on and green on the board are flashing. On the wiznet module, yellow is on and green is flashing.

The only chips that can be re-seated are the ones closest to the sips. Everything else is soldiered to the board.


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

Did you try a reset of the e682?


Reply
Page 1 / 3
Share: