E682 power problem
 
Notifications
Clear all

E682 power problem

32 Posts
8 Users
0 Reactions
9,687 Views
ksmith247
Posts: 418
Topic starter
(@ksmith247)
Honorable Member
Joined: 14 years ago

Ok. I did all the tests everyone mentioned and they all passed. The really odd part is now I am getting the correct voltage to the two jumpers.

You guys are amazing. You all can apparently fix these things over the internet with just suggestions.

I knew I joined this board for a reason. Hopefully one day I can repay the favor to someone needing help.

Again, thank you for all the help. The community here is really amazing.


Reply
ksmith247
Posts: 418
Topic starter
(@ksmith247)
Honorable Member
Joined: 14 years ago

So I spoke too soon. I installed the IC's since the previous test passed and now I am having the same issue. Since it did work I am lead to believe I have a bad soldering joint somewhere. My only guess is, since I was moving the board around, maybe the bad solder made connection until I moved it again.

Does this sound like it could be the reason? Any idea where I should start checking soldering joints, or is it best to just go back through and add to all of them?


Reply
Posts: 121
(@jeremy-jackson28)
Estimable Member
Joined: 11 years ago

I would just flow them all if it were me.

Sent from my iPhone using Tapatalk


Reply
ThinkAgainAgain
Posts: 230
(@thinkagainagain)
Reputable Member
Joined: 12 years ago

That (solder) and swap those jumpers out... I've gotten a bad jumper with my card/build

Sent from my SAMSUNG-SM-G890A using Tapatalk


Reply
JP90
Posts: 376
 JP90
(@jp90)
Reputable Member
Joined: 19 years ago
ThinkAgainAgain wrote:That (solder) and swap those jumpers out... I've gotten a bad jumper with my card/build

Sent from my SAMSUNG-SM-G890A using Tapatalk

I agree with the bad jumpers I had one on a hard drive, one side of the jumper was not making a connection on the pin, worth a try.

Gary


Reply
Page 6 / 7
Share: