E682 power problem
 
Notifications
Clear all

E682 power problem

32 Posts
8 Users
0 Reactions
9,687 Views
ThinkAgainAgain
Posts: 230
(@thinkagainagain)
Reputable Member
Joined: 12 years ago

Any luck?

Sent from my SAMSUNG-SM-G890A using Tapatalk


Reply
ksmith247
Posts: 418
Topic starter
(@ksmith247)
Honorable Member
Joined: 14 years ago

I have not been able to get on in a few days. Looks like I have a lot to look at and test from all the posts that have been posted.

I really appreciate all the help everyone is giving. I will go through all the posts and try all suggestions and give results.

thanks everyone.

I did check the LED that was not lighting up and it does not light up just using my multi meter without the PS, but the other do light up. Could a bad LED be the cause of my issue?


Reply
ksmith247
Posts: 418
Topic starter
(@ksmith247)
Honorable Member
Joined: 14 years ago

Now this really makes no sense. I have done nothing to the board, but now the 3.3v and Px34 LED's are lighting up. I swear, I don't drink and solder.


Reply
ksmith247
Posts: 418
Topic starter
(@ksmith247)
Honorable Member
Joined: 14 years ago
ThinkAgainAgain wrote:Your soldering looks neat and clean, but I can't see if there's and gaps or areas of little to no solder (not saying there is) just can't see.

Sent from my SAMSUNG-SM-G890A using Tapatalk

Thanks for the compliment. I just learned to solder with a few renards and a couple PX1's


Reply
ksmith247
Posts: 418
Topic starter
(@ksmith247)
Honorable Member
Joined: 14 years ago
Jeremy.jackson28 wrote:I had this problem. It was a jumper I left off. Middle of board toward the top. On the atml uchip. Above cpu

Sent from my iPhone using Tapatalk

Just checked, and it is there.


Reply
Page 5 / 7
Share: