Notifications
Clear all
Dec 23, 2014 12:20 pm
The fuses are 5A so you are limited there - but - if you were thinking of running hundreds of pixels without power injection at several points then it would never work anyway...
Dec 23, 2014 12:27 pm
budude wrote:The fuses are 5A so you are limited there - but - if you were thinking of running hundreds of pixels without power injection at several points then it would never work anyway...
Even with a 5A fuse on each, the 6.35mm terminal block is only good for 30A max, running 5A one each could push 40A.
Dec 23, 2014 12:29 pm
apollosmith wrote:Where did you get this number? I don't see it posted in the E682 documentation. If true, this would by far be the limiting factor for most setups.
"Upgraded heavy-duty pixel power connectors rated for a total maximum of 64 amps of pixel power" I just used this number divided by the 16 connectors.
They are rated at 8 amps by Molex.
Dec 23, 2014 1:00 pm
dlovely wrote:Even with a 5A fuse on each, the 6.35mm terminal block is only good for 30A max, running 5A one each could push 40A.
I also think if it is fuse at 5 amp I only want to be at 80% of that.
Feb 14, 2015 5:30 pm
So, back to the original question. If there are 16 universe outputs, then how many 12v pixel bulbs can each universe handle at 12v?
