I've built several E682s and they all work great. I've tested with xlights with a prop or 2 hooked up no problem.
Now I can't seem to figure out how to map my E682 full setup to xlights. I've attached a screenshot of the E682 web config setup page. I want to attach a prop or 2 to each port. I don't think I'll need any more than 170 pixels on one output, but it is just an estimate. My problem is I don't see how to set this up in xlights, since some outputs will start on odd places such as universe 2, channel 97.
I could set every output port up as a single universe, but that only works I don't have more than 170 pixels on a port.
I'm I going about this the wrong way?
Questions to ask yourself:
What props are hanging off of each physical output?
How many pixels do each of them have? How many channels is that?
What universe are you using for the first prop? (The others will fall in line.)
Are you starting a new universe for each output, or are you using them in a continuous chain (output 1: U1C1 - U1C210, output 2: U1C211 - U2C35, etc.)
Answering those simple questions makes it easy to setup the E682.

