Notifications
Clear all

E681 Problem

20 Posts
10 Users
0 Reactions
7,228 Views
Posts: 347
Topic starter
(@dougd)
Reputable Member
Joined: 19 years ago
jklingert wrote:Any chance you installed the sockets backwards?

WOW! This is the only thing that makes sense. I will check this when I get home.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

I doubt you would do it multiple times - but... you can insert the plugs in off a row a pins - I've done that myself a couple times...


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
budude wrote:I doubt you would do it multiple times - but... you can insert the plugs in off a row a pins - I've done that myself a couple times...

+1 on that 🙂 I've done this a couple of times while cursing the lights and controller to discover it was the a bonehead assembler error .


Reply
Posts: 347
Topic starter
(@dougd)
Reputable Member
Joined: 19 years ago

No, wiring and sockets are correct. More information to follow. I am going to put the boards side. The one that works is on the porch up high being used for mood lighting. I am going to take it down and put the boards side by side and do better testing tonite. I am sure it is something I am doing.The WS2801 pixels working is giving me a mental block.


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago
chelmuth wrote:can we get top and bottom photos of malfunctioning board. closer and clearer the better.

Photos of the front and back of the board would help.

A couple of ideas: The GECE are 5V pixels, do you have the power jumpers set correctly for 5v and are you using a 5vdc power supply? Remember to Save 0 and Boot 999 after making the changes. Sharing a screen capture of the config screen after a reboot would also be helpful. One last tip, the GECE need to be connected to the board when the board is powered up and not plugged in after the board boots.


Reply
Page 3 / 4
Share: