I think Jim is likely celebrating the Holidays, so I'm hoping he replies to an email follow up I sent him.
I have had an odd issue with a new 6804 since I built it - Jim and I spoke, But we wanted to test the Wiznet form my working system in this one to see if that was the issue, and I finally got to that since the crowds are slowing down for the show. And it didn't fix I....
What happens -
Power up the E6804, no issues - Pings on there IP - Red and Green lights.
Hit the web page, and BAM the Green light goes out, Half the page loads and it stops loading right after the first 2 parts of the Output Config (Output 1 : WS2801, length 50 .... and Stops loading the page).
At this point, you can no longer load the page again unless you power reset the unit. It does still ping, but that's it.
I have done some Network Traces and can see that :
1. On initial boot and hit the page, the line in the trace is my laptop sending data back, but I get no packets back. (and the entire session never ends with a three way TCP handshake - not like my working system).
2. If I try after the crash, I can try to hit the webpage, and I do get a reply from the E6804, but nothing to do with a webpage reply - and no session attempt is made.
Anyone ever had this issue or have an idea? I'm not going to use this one until next year, but I need to test 400 12mm Pixels VERY soon or I'll be stuck if any of them are defective.....
Thanks
I've only seen pictures of a 6804, so this is nothing specific to that device. When I've seen problems like that with other equipment (networking devices, appliances, etc) it was usually because there wasn't enough source power OR the processor was over heating. In the case of source power, essentially having to ramp up the CPU and serve the web pages might cause more power draw and then it isn't able to get enough... essentially crashing things. Similar with the processor/CPU overheating and causing some sort of system crash and being able to do anything more.
a) are you sure power input is solid... no shorts or anything inbetween the source and the processor/IC?
b) does it seem like anything is getting overly hot?
Again, this is totally speculation and just something to consider or look into!
Do you have a wireless nic card? If so, disable it and retry.
superdave wrote:I've only seen pictures of a 6804, so this is nothing specific to that device. When I've seen problems like that with other equipment (networking devices, appliances, etc) it was usually because there wasn't enough source power OR the processor was over heating. In the case of source power, essentially having to ramp up the CPU and serve the web pages might cause more power draw and then it isn't able to get enough... essentially crashing things. Similar with the processor/CPU overheating and causing some sort of system crash and being able to do anything more.a) are you sure power input is solid... no shorts or anything inbetween the source and the processor/IC?
b) does it seem like anything is getting overly hot?Again, this is totally speculation and just something to consider or look into!
I've got a pair of 6800s, essentially an early version of the 6804. I agree, it sounds like either a power or connection issue.
One thing you could try is a fast ping. Under windows, run: ping -t -w 1 This will ping the interface every millisecond. If that replicates the issue, it's probably more related to the ethernet interface. If the device continues to respond after running the fast ping for a minute or so, it makes me wonder about either the prop chip or the eeprom.
Connection issue or wiznet.
Have 4 E6804's in the show this year, one developed a funky wiznet, other then that, swapped it out, and all is happy!

