e6802 Not Working
 
Notifications
Clear all

e6802 Not Working

5 Posts
4 Users
0 Reactions
1,822 Views
Posts: 15
Topic starter
(@jbaker2290)
Eminent Member
Joined: 14 years ago
[#25586]

Hello, I just mounted my board in my new enclosure re ran the cat 5 and got it all hooked up again, however I get no lights on my pixels. I am able to connect to the configuration page and put it into a test mode, and the green light flickers on the board showing e1.31 signal. I also put a meter across all the string hookups and I am getting full voltage, yet still no lights. I really dont think there is anything wrong with the lights. Any thoughts would be welcome. Thanks


4 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

pixels wired correctly ?

proper end as input

clk ,data reversed
configured correctly in the web url ?

did you do a save 0 after applying your settings ?


Reply
Posts: 145
(@nkyspike65)
Estimable Member
Joined: 19 years ago

Are you giving power to both J18 & J19, or only J19?


Reply
Posts: 1249
(@jstjohnz)
Noble Member
Joined: 17 years ago

Was everything working (pixels lighting up) before you mounted everything in the enclosure?


Reply
Posts: 15
Topic starter
(@jbaker2290)
Eminent Member
Joined: 14 years ago

After reviewing everything. I made a really noob mistake last year I had 12v&5v lights on the same board. Now with my new enclosures I decided to split it into two boards. I plugged my small test strip into my board that's what isn't working because they are 12v and my board is 5v. Thanks for your help. Can't believe I didn't notice sooner.

Sent from my iPhone using Tapatalk


Reply
Share: