E131 Bridge questio...
 
Notifications
Clear all

E131 Bridge question

8 Posts
4 Users
0 Reactions
2,029 Views
Posts: 251
Topic starter
(@don-gillespie)
Reputable Member
Joined: 13 years ago
[#49504]

I am having a brain fart, I am helping a fellow member with an E131 bridge that he bought, he couldn't get it to connect with his computer so he did a hard reset on the device, he did the mode and reset button green light flashed 10 times. I have looked at all my notes and I can not find what IP address we can use after the hard reset, we have tried 192.168.1.206 but no luck. Who has a great memory and can tell me how I get the damn thing to connect so we can get his lights going?


7 Replies
Kev7274
Posts: 2037
(@kev7274)
Famed Member
Joined: 13 years ago

Did you try 169.254.74.73?


Reply
Posts: 251
Topic starter
(@don-gillespie)
Reputable Member
Joined: 13 years ago
Kev7274 wrote:Did you try 169.254.74.73?

I will have him try that when he gets home


Reply
Posts: 2229
(@plasmadrive)
Famed Member
Joined: 15 years ago
Don Gillespie wrote:I am having a brain fart, I am helping a fellow member with an E131 bridge that he bought, he couldn't get it to connect with his computer so he did a hard reset on the device, he did the mode and reset button green light flashed 10 times. I have looked at all my notes and I can not find what IP address we can use after the hard reset, we have tried 192.168.1.206 but no luck. Who has a great memory and can tell me how I get the damn thing to connect so we can get his lights going?

HARD RESET

It is possible to do a hard reset and erase all of the configured parameters in the E1.31 bridge and return it back to the factory default settings. To do the hard reset and lose all of your settings and return the device to the factory settings: Press the MODE and RESET buttons at the same time and hold down the MODE button while you release the RESET button. The ACT LED will flash a status code, after the ACT LED flashes 10 times, release the MODE button. This will wipe all device configuration settings and reset them to the default factory settings and will force the generation of a new random MAC ID for the unit if the MAC ID chip (IC 9) is not installed on the board.

Is everything on a router or just tied to the computer? I'm not a very good computer guy but I don't think DHCP will work without a router.. Anyone know for sure?

According to the Wiki, as far as I can tell, assuming the DHCP mode didn't obtain an address, the 169.254.74.73 would be the default. If that is the case your computer (assuming no router) would have to be set to some address like 169.254.74.XX (not 73) and not set for DHCP. But again, I may be wrong..


Reply
Posts: 317
(@dvc2013)
Reputable Member
Joined: 14 years ago

Here’s what works for me whenever I have a problem with my Bridge.

After resetting to defaults as posted above by plasmadrive do an additional reset by pressing the reset button. After that you would connect to the bridge at 192.168.1.206.

This works for me every time. Also make sure the computer you’re using is in the same address range as the bridge.


Reply
Page 1 / 2
Share: