Dead esPixelStick?
 
Notifications
Clear all

Dead esPixelStick?

49 Posts
6 Users
0 Reactions
6,207 Views
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

No . Use a jumper pin 0 to gnd onboard


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

If this fails then you can try erasing the firmware with Espressif's Esp flash tool .

Basically install the tool , select your module type then select com-port and hit erase .

Wiat for finish then exit to load new firmware .

https://www.esp32.com/viewtopic.php?t=60&start=20


Reply
Posts: 28
Topic starter
(@jackofmanymasterofsome)
Eminent Member
Joined: 5 years ago

Took me a few since I don't deal with electronics at all to realize jump the GPIO 0 pin to the ground pin. This does nothing for me. I still get the same message.


Reply
Posts: 28
Topic starter
(@jackofmanymasterofsome)
Eminent Member
Joined: 5 years ago

I didn't notice your response. New to this forum and things looked out of order


Reply
Posts: 28
Topic starter
(@jackofmanymasterofsome)
Eminent Member
Joined: 5 years ago

I've jumped the pins, still didn't work. Tried the esp flash tool and still can't get pixel stick flash tool to work


Reply
Page 3 / 10
Share: