Notifications
Clear all

Daisy chain px1

8 Posts
4 Users
0 Reactions
2,238 Views
Posts: 281
Topic starter
(@bert-nc)
Reputable Member
Joined: 18 years ago
[#39053]

Can you daisy chain a renard controller after a px1?
I had plans to run from my show computer----renard ss16---- px1 ---renard ss16----px1
However tonight I could not get any "blinky flashy" after the first px1
Tried two different px1's with the same result
The second renard ss16 works fine if I remove "skip" the px1
Did not have the second px1 hooked up
Was checking each section as I progressed down the line
Only running 50 pixels, grouped 5 pixels together, so only using 10 channels on the px1

Thanks in advance
Bert-nc


7 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

you should be able too daisy chain them as long as you dont go over the amount of channels a renard chain can run are the renards and px1s all set at 115200 baud rate do you have the pin on the renards for rs485


Reply
Posts: 281
Topic starter
(@bert-nc)
Reputable Member
Joined: 18 years ago

Will check pins on renard s
Baud rate on 57600 for px1
as I am unable to change the baud rate on the
Renard ss16. 57600 was default rate for renard when I purchased them
If I am not mistaken
Only running 76 channels with present set up
Thanks in advance
Bert-nc


Reply
THurrle
Posts: 1211
(@thurrle)
Noble Member
Joined: 17 years ago

Go in to manage profiles, click output plug ins,click on renard dimmer then plug in set up. Click serial set up and there you can change the baud rate.


Reply
Posts: 281
Topic starter
(@bert-nc)
Reputable Member
Joined: 18 years ago

Correct me if I am wrong, but I was thinking I would have to change the
firmware in the pics with the ss16 which would require them to be reflashed
To change the baud rates
Reflashing the pics is what I am unable to do
And I know everyone should have a pic programmer but with my very limited display just has never been an issue
I can set baud rates for the sequence when I create the sequence
With the limited number of channels I will be doing I thought 57600 should be sufficient to handle the load

Thanks in advance
Bert-nc


Reply
Page 1 / 2
Share: