Hi, I'm building a custom string of WS2811 nodes in order to control the specific length between nodes. Each string will be 25' with 30 WS2811. Currently I am testing with 5v LEDs but may move to 12v for my final product. I purchased 3pin pigtails with 22 gauge wire, and am now concerned I should have bought the larger connectors with 18 gauge wire. I would really appreciate if someone could point me in the right direction regarding what gauge of wire I should be using, as well as how many of these strings I could potentially mate before needing to inject power. Ultimately I will have 20 of these strings all together for some mini trees in a display and am trying to figure out how to best manage the power.
To be clear, these won't be the standard 8mm WS2811 Nodes chopped up and spliced back together at the desired lengths, but a custom built WS2811 F5 circuit for each node. I've got nodes done, just need a little help with the cabling.
I hope I've explained this well. I've just started in this hobby and am hoping to get this project ready for this next holiday season.
Thanks in advance!
Whether custom built or off the shelf, The tri colored LEDs will draw current. You use the correct value in your power calculations Keep in mind that current flow through the wire changes at each pixel. Wire voltage drop is based on wire length between pixels and the current through the wire at each segment. The longer the distance between pixels, the thicker the wire you will need to use.
Thanks! So the strings will be 30 LEDs with 10" spacing, Total of 25'. I am hoping I can get 90 LEDs (3 Strings) per power drop, more would be great!. I was planing to run 2 conductor 16 gauge for my power injection. So would using the 22 gauge on the LED stings be ok, or should I plan for 20 or 18 gauge for the strings?
You would still need to inject every 70" or so
Do the calculations...
Assuming that you would want to accommodate 100% on for every RGB LED using 22 AWG wiring for the string...
The precise way of calculating the voltage drop across the string would be to add up the voltage drops in each 10" inter-pixel segment. However, using average current (i.e. current averaged over all of the wiring segments) which is half of the near-end current and total resistance is close enough (as would using total near-end current and average wire resistance, amounting to the same thing).
Take length L in inches and assume 10" separation between pixels...
The average current draw over that length is L/10 * .060A / 2 ( L/10 is the number of pixels, .060A is draw per pixel, and the '2' division factor is used to get average current from the maximum current at the power source).
The resistance over that distance is L/12 * 16mΩ/foot * 2 (the 12 is used to convert inches to feet, the 16mΩ is the resistance per foot of 22 AWG wire, and the factor of 2 is take into account the voltage drop over both the power and ground wires).
The voltage drop at the far end of the string is then L/10 * .060A /2 * L /12 * 16mΩ * 2 = L * L * 8e-6 (L is in units of inches, the voltage drop is in units of volts).
For 25' string (i.e 300") this would result in a voltage drop of 0.72V from the near end to the far end, which might be a bit much for 5V strings but likely OK for 12V strings.
Anyone see any major flaws in either the logic, the algebra or the calculations?
