Controller question
 
Notifications
Clear all

Controller question

11 Posts
6 Users
0 Reactions
3,255 Views
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago
tucsonlights wrote:I don't know how many outputs you have used on your e682 but the e682 IS a Bridge and can output DMX to the Renard. Of course your ss24s must have the DMX firmware.

The E682 can output DMX, but it is not necessary as the E682 can output Renard 57600. In this case 16 strings of 50 pixels will not max out the E682, but the the Renard protocol will take up 1 entire group (4 outputs) of the e682.
The new Falcon v2 is an option as well as the Pi player, which can output Renard as well. The Pi is super cheap and can also output e1.31 to your pixel controller as well. You can always run your e682 directly off of your computer and still maintain your RS232 or RS485 output to the Renard.


Reply
Posts: 28
Topic starter
(@tcraft29)
Eminent Member
Joined: 13 years ago

I think the Falcon v2 would save me some money in not having to purchase a bridge. Can I still daisy chain the Renards or do I have to run each one off of the Falcon?


Reply
Posts: 1120
(@4586shaggy)
Noble Member
Joined: 14 years ago

Renards will still run daisy chained.


Reply
Posts: 28
Topic starter
(@tcraft29)
Eminent Member
Joined: 13 years ago

Excellent. Thanks for all the help everyone!


Reply
Posts: 99
(@sulrich)
Estimable Member
Joined: 13 years ago

Double up the strings and power inject where/if necessary, that would utilize 8 of the 16 outputs, us 4-1 in Renard format, take a look at SANDEVICES manual, it shows the pin out to go from the 4 prong green connector to a CAT5 plug to plug into your Renard..
I did it last year with my Renard TR24's..

Basically use 8 outputs of 100 pixels, utilizing 1-1thru1-4 and 2-1thru2-4 for your pixels. this is only 8 unicast universes if you want easy. Then in the E682 controller set the output of 4-1 to RENARD, create the pin out connector to RJ45 as mentioned and it is pretty much that's it. no additional purchase needed. In the E682, just enter 1/3 of the total outputs.. so if you run three 24 port Renards, just put 24 in the E682 since it multiplies it by 3..

I hope I got this right, pretty sure it is


Reply
Page 2 / 3
Share: