Connector found mis...
 
Notifications
Clear all

Connector found miswired

11 Posts
6 Users
0 Reactions
4,102 Views
Posts: 825
 DanJ
Topic starter
(@danj)
Prominent Member
Joined: 13 years ago
[#46330]

After making up 11 pigtails for this year's display (testing each as I am going....), I found that pigtail #12 was not working. In fact, when I connected it between my controller and a test prop, it burned out the first pixel on one the test prop, which I will now have to swap out (arrgh). After trying again with another section of cat5 cable, I got the same result--didn't really think about the possibility one of the connectors might be wrong... I then popped the connectors off of the new cat5 cable and ohmed out the M/F ends of the connector. I found that the top pin of the female half was the BR lead, the left pin was the GR/Y lead, and the right pin was the BL lead. I checked the male half and found the GR/Y was the top pin and the BL was the right pin. Checked another M/F pair and found they were the same as the male half. Just figured I would share here. I will probably ohm out a few more as I go forward....


10 Replies
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

I actually just had the same issue. I ordered a bunch of Tee connectors from DIYLEDEXPRESS a couple of years ago and just started using them. I have 5 arches and injected after the third. The last 2 arches wouldn't work. Ended up it was the Tee connector. I plugged in a different one and it worked. Ended up throwing it in the trash.


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

I cannot express enough, "Check Everything!" Even the best supplier is at the mercy of the different manufacturers. Almost everything that is made at the plants (and workrooms) is sent on to the customers in some of these shops. NO QUALITY CONTROL is the NORM.

A good multi-meter set on continuity (or even an old fashioned light bulb with a battery attached) is your friend.

Happy DIYing!


Reply
Posts: 127
(@kreeve)
Estimable Member
Joined: 11 years ago

Yep, Last year the pixabulbs I received from DIY LED Express where wired different than in past years. Luckily I checked everything out first. Arghhhhh.

Kevin


Reply
Posts: 944
(@didjareally)
Noble Member
Joined: 12 years ago

i always check continuity of the pigtails/extensions, humans make mistakes and can put a wire in the wrong spot during assembly. It takes time to test them all but saves pixels and frustration in the end.


Reply
Page 1 / 3
Share: