I am using 12v pixels this year. I am testing the limits of cable length, #of pixels per single connection, voltage drop, different guages, etc. I am at 150 pixels and even white seems good at the end. However the voltage at the end of the 150th pixel is down around 7 volts if I remember correctly.
My question is will this be harmful long term to the electronics in each pixel toward the end feeding them such low voltage? I would hate to stress the pixels and cause premature failure simply because I didn't run one additional wire to inject power. On the flip side if the colors are good with white and the brightness is consistent I don't want to run it unless like I said it would cause damage long term.
What do you guys think?
It depends on the design of the pixel. Many 12v pixels have a voltage regulator in each pixels. These will take a wide range of power input and bring it down to 5v or less for the pixel circuit to use. In this design so Lon as the incoming voltage is about 1.5v higher than the pixel needs the net result will be exactly the same. This is often around 6-6.5 volts. Below that threshold the regulator won't be able to do its job and likely the pixel won't work at all. There's an upper limit too. This varies with the specific regulator chosen. Some will allow as high as 28v. But even if it does allow for that wide, the regulator has to do something with that voltage to bring it down. It will dissipate it as heat. And pixels are sealed and don't have any thermal management. So I wouldn't go driving them a lot higher for any length of time. This is the least power efficient type of pixel because a lot of power is wasted as heat. But it is the most tolerant of bus voltage variation.
Another way pixels drop voltage is by using multiple LEDs per IC. This method usually uses 3 LEDs in series to bring the required voltage up to close to 12v. If you take the 3.7 Vf of the 3 LEDs you get something like 11.1v needed across the set. In this case high can't let your bus voltage go below the sum of the highest Vf of the number of LEDs in series. This is the most power efficient way to run the pixels but there's not much voltage tolerance benefit to using a 12v pixel.
Another thing to keep in mind is that your voltage drop will change with temperature. The resistance of a wire will change as the temperature changes. Wire is usually specified at 25C. It can change enough to matter when you're at -5c In my part of the country it can range from -10F to 80F during the decorating season. (Sometimes in the same day). So I need to make sure my display can handle that shift across the whole range. What works great in the workshop doesn't always work right at -10!
But to answer your question, no long term use that low won't damage the pixels. If it works now, it will continue to work the same so long as the environment stays the same.
--Jon Chuchla--
Sent from my iPhone using Tapatalk
Technician, are you sure you got the right thread? I think you wanted the guy with the Chinese dj pars.
--Jon Chuchla--
Sent from my iPhone using Tapatalk
Thanks Jon! My area can have wide temperature fluctuations as well so how can I account for that? I am using 12v 2811 pixels from diyledexpress 2015. This is my first true year with pixels, last year I just played around to learn the ropes a bit. I have one 35ft run that is doing great today at 60F with separate power and data feeds but the last thing I want is to mount something 20ft off the ground only to find when it turned cold I have issues.
Sent from my Nexus 6P using Tapatalk

