Hello, I'm pretty sure the answer is no but I will ask anyways. Although I do vaguely remember seeing something similar somewhere, but I probably made it up.
I have a pixcon16 that was given to me by my cousin. I am planning on trying out some pixels next year, as so far my show has been entirely AC. I'd obviously like to use the controller I have instead of buying another one.
The thing is, the pixcon16 only supports 340 pixels per port, which is relatively low compared to other controllers. That's going to make it quite annoying to use. For example, I have a clump of 3 spiral trees I would like to convert to pixels. I would need to run 2 separate data lines just for those 3 trees!
So here is my question. Has anyone designed a board that lets me combine 2 or 3 outputs from my controller into one larger output right in the controller box, and then I can just run one cable?
As I said, I'd be surprised if anything like this actually exists. But it'd be pretty nice if it did.
Thanks!
You can run just one cable. Put the controller out at the prop and run a data cable to it. Same effect. You really do not want a lot of pixels on a single chain. you start to get issues with refreshing and start-to-end latency.
You're right I didn't think about latency. I guess I will just plan on using multiple data wires.
