Changing Display
 
Notifications
Clear all

Changing Display

6 Posts
6 Users
0 Reactions
1,855 Views
Posts: 251
Topic starter
(@don-gillespie)
Reputable Member
Joined: 13 years ago
[#29570]

for 2014 I am going to move some stuff around, and I am going to add some more pixels for next year, I currently have a pixel tree, with 16 strings of 50 WS2811 pixels all 5 volt, I want to add some more to my garage gable total length 28 feet, also on my house gable roughly 68 feet of gable to work with, the question I have is mainly for the house am I going to need some power injection over 68 feet? and if I do at what length should I be injecting power at?


5 Replies
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 19 years ago

What will the linear cable lengths be? I have 2 controllers across the front of the house. Each does its own side, split from the middle. This way my cable runs are shorted. My "extensions" are about 25 feet. I did not measure them exact, I just ran the wire as I needed as the display was thrown together at the last minute. Before you go crazy I suggest you think about controller placement to minimize cable runs and then take a controller, a set of pixels and an extension cable to see how it will perform. It if does not work well enough then you may have to power inject. Depending on your layout and distances you may benefit from power injected from both ends of the string or just inject in the middle only.

So, more details are needed and some experimentation will help.


Reply
Jeff Millard
Posts: 1450
(@jeff-millard)
Noble Member
Joined: 19 years ago

Don, with 5 volt pixels spaced 4" I see color shift starting with pixel 43. So I make lateral strings 42 pixels long. But if it's a continuous string with voltage injection I attach the injection between strings of 50 just for simplicity. I tested a string 160 pixels long with the voltage attached at both ends and between 80/81 and there was no color shift. I used 16 gauge wire for the voltage injection but no run was longer than 25'. I was using the crappily made TLS 3001 Ray pixels when testing. Logan can give you insight on how bad those pixels are.

Jeff


Reply
Lionking_Tx
Posts: 780
(@lionking-tx)
Prominent Member
Joined: 15 years ago
Jeff Millard wrote: I was using the crappily made TLS 3001 Ray pixels when testing. Logan can give you insight on how bad those pixels are.
Jeff

But Ray charges more for them 😛


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
Jeff Millard wrote:Don, with 5 volt pixels spaced 4" I see color shift starting with pixel 43. So I make lateral strings 42 pixels long. But if it's a continuous string with voltage injection I attach the injection between strings of 50 just for simplicity. I tested a string 160 pixels long with the voltage attached at both ends and between 80/81 and there was no color shift. I used 16 gauge wire for the voltage injection but no run was longer than 25'. I was using the crappily made TLS 3001 Ray pixels when testing. Logan can give you insight on how bad those pixels are.

Jeff

I can show you just how great these tls 3001 are 🙂

I am ordering another 64 strings of these I have not had any issues with them ant the colors are way better than I have see on other pixels .


Reply
Page 1 / 2
Share: