cable sliding out
 
Notifications
Clear all

cable sliding out

17 Posts
11 Users
0 Reactions
8,904 Views
Kev7274
Posts: 2037
(@kev7274)
Famed Member
Joined: 13 years ago

I use Ferrules on my connectors also. One of the best things I did. Don't have to worry about stray strands.
I'm not sure if different kits use the same specs for the ferrules,but in mine,I use white and they fit perfect.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Ferreles add additional protection by reducing wire breakage. Ferreles insulated ends protects the wire so it is not bent at strip point


Reply
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago
AJR214 wrote:Your wires look to be about 18 gauge leading into the ferrules. On the green terminal blocks you are using the 0.5mm (orange) ferrules (your box has it listed as 22 gauge). Is that the size that fits the terminal blocks and the 18 gauge wire the best?

This is correct. The leads are from DiyLEDexpress, so they are supposed to be 18 gauge. I just used the smallest ferrule that fit the wire which happened to be the orange ones. Crimping these takes less time than soldering them.


Reply
Posts: 84
(@ajr214)
Estimable Member
Joined: 8 years ago
Keith R wrote:This is correct. The leads are from DiyLEDexpress, so they are supposed to be 18 gauge. I just used the smallest ferrule that fit the wire which happened to be the orange ones. Crimping these takes less time than soldering them.

Speaking of soldering, would I want to tin the strands before putting on the ferrules? I'm thinking not, but just want to know if others do.


Reply
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago

I suppose you could tin just the end to keep the wires from fraying when putting them into the ferrule, but I do not.


Reply
Posts: 299
(@dcamron)
Reputable Member
Joined: 10 years ago
AJR214 wrote:Speaking of soldering, would I want to tin the strands before putting on the ferrules? I'm thinking not, but just want to know if others do.

No. That would prevent the crimper from doing its job correctly. You would have malformed ends that wouldn't fit well in a connector.


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Though tinning ends was a norm around here (for a very long time), practice has found that any time the end is to be "squeezed" (by any means) it is best leaving them bare. Tinning may hold the wires while they are being screwed down, or crimped, but pressure will cause solder to migrate and loosen some connections. We don't know which ones will loosen until time has passed, but it does happen.

As a practice, the only wires we tin today are ones that are going to be soldered together, or to a pad on a board. If it is going to be crimped, screwed down, or clamped together, we leave the alone.


Reply
Page 2 / 2
Share: