Can’t find anything on breaking in new pixels bullets and strips .
Question is what your breaking consisting of time wise ? Or do you just test and put up till it’s time ?
Was suggested by a good source that to run bullets for days before storing so curious to what others here do .
Sent from my iPhone using Tapatalk
Theories vary on burning in Pixels. I test them before use, then put them on the prop and forget about it. I do test my house outlines again before install as it is much easier to fix them in the house vs on the house. I have not had a failure between putting them on the prop and putting them out for display. Most of my Pixels are from Ray, and I have not had a failure in 2 years at our new home.
rstehle wrote:Theories vary on burning in Pixels. I test them before use, then put them on the prop and forget about it. I do test my house outlines again before install as it is much easier to fix them in the house vs on the house. I have not had a failure between putting them on the prop and putting them out for display. Most of my Pixels are from Ray, and I have not had a failure in 2 years at our new home.
That’s good to hear
Sent from my iPhone using Tapatalk
Ok so running some strips to test and break in and not sure what happened or how but the bottom half of my screen went into something weird never seen this before on any pixel pops. Did I do something wrong 
Sent from my iPhone using Tapatalk
wilmar wrote:Ok so running some strips to test and break in and not sure what happened or how but the bottom half of my screen went into something weird never seen this before on any pixel pops. Did I do something wrong![]()
Sent from my iPhone using Tapatalk
How’d I end up in developers tools ?
Sent from my iPhone using Tapatalk
