Bad wire or somethi...
 
Notifications
Clear all

Bad wire or something else?

15 Posts
6 Users
0 Reactions
6,328 Views
Posts: 34
Topic starter
(@fabiousa7)
Eminent Member
Joined: 11 years ago
[#57426]

Hi all,

I'm trying to get the arches I recently built up and running but facing some challenges.

Is there a number of ohms that is too much resistance for the data to work? I think this wire I bought isn't too good, it's 18ga and I was trying to go about 18ft from my power box to my first arch and I get 5 white pixels on.

I tried:
plugged other pixel strings in place
Re-did my pigtail connections
Moved to other ports in the controller
Unplugged the chained arches to drive just the first one alone

Arches 4 and 5 are closer to the controller and work fine.

I have power injection between each arch so 75 pixels.

Any help is welcome.

Sent from my SM-N960U using Tapatalk


14 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

!8/3 is fine .
Did you pretest each arch to verify Data in ?


Reply
Posts: 34
Topic starter
(@fabiousa7)
Eminent Member
Joined: 11 years ago

No, I didn't. But now that you said it i'm feeling pretty dumb for not doing it.
Last year I bought 6000 pixels directly from a manufacturer in china, I tested about 50 of them and didn't have any issues, so I just trusted that the rest was going to be good as well.

Earlier today (before it got dark) I tested with two fresh strings of pixels and they didn't work either, that's why i was leaning towards the wire.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Which controller are you using ?
Check your controller configuration ?
Check All connections including data at controller .
Sequence configuration is correct for controller output ?
Check fuses for each output on controller .
You're certain you're connecting to the input end of each string of pixels ?

I believe 15ft. from the controller was an average max distance before a null pixel would be suggested/required to extend for further distance .
You should still see data though at 18 ft .

White pixels does signify no data as you suspect .

Don't beat yourself up over not pretesting . The excitement and time of year add to complexity !

Great work on the arches .


Reply
Posts: 34
Topic starter
(@fabiousa7)
Eminent Member
Joined: 11 years ago
angus40 wrote:Which controller are you using ?
Check your controller configuration ?
Check All connections including data at controller .
Sequence configuration is correct for controller output ?
Check fuses for each output on controller .
You're certain you're connecting to the input end of each string of pixels ?

I believe 15ft. from the controller was an average max distance before a null pixel would be suggested/required to extend for further distance .
You should still see data though at 18 ft .

White pixels does signify no data as you suspect .

Don't beat yourself up over not pretesting . The excitement and time of year add to complexity !

Great work on the arches .

Thank you for the suggestions.

I use sandevices E-682.

I was using the test function on the controller to reduce points of failure.

I tried multiple ports, and channels configuration.

Tomorrow I plan to move my controller closer and try a shorter cable, if that works I'll then proceed to try using null pixels (haven't done that yet) that way I can place the controller where I want for next year.

I'll report back once I try it.

Sent from my SM-N960U using Tapatalk


Reply
Page 1 / 3
Share: