AlphaPix 3 Controll...
 
Notifications
Clear all

AlphaPix 3 Controller Universe Issue

11 Posts
2 Users
0 Reactions
1,922 Views
Posts: 40
Topic starter
(@df101)
Trusted Member
Joined: 9 years ago
[#54833]

I have a alpha pix 3 controller running software version 2.14. Each output can control 340 pixels. Start channel always changes to 512 after saving/updating settings. Don't have this issue when using a number less than 512. Below is the setup on the alphaPix controller, before and after saving/updating settings. Appreciate any help. Maybe firmware needs updating

Before saving/updating Settings
output 1 StartUniverse =1 StartChannel=1 PixelsConnected=250
output 2 StartUniverse=3 StartChannel=751 PixelsConnected=250

After saving/updating settings
output 1 StartUniverse =1 StartChannel=1 PixelsConnected=250
output 2 StartUniverse=3 StartChannel=512 PixelsConnected=250


10 Replies
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

Once you hit 510 channels you start the next universe, channel 1.
250 pixels x 3 channels =750 so 750 - 510 = 240 so 250 pixels uses all of universe 1(510) and 240 of universe 2.
Output 2 should start universe 2 channel 241


Reply
Posts: 40
Topic starter
(@df101)
Trusted Member
Joined: 9 years ago

With this controller each out put should be able to handle 340 pixels, 1020 channels. By default the settings are set to 340 pixels. Output 1 should be able to have universe 1 and 2. Meaning output 2 can start at universe 3. That way I don't have to run so many data lines to my matrix. Its why I ordered this controller. Appreciate the help


Reply
Posts: 40
Topic starter
(@df101)
Trusted Member
Joined: 9 years ago

I think I understand. If output 2 starts at universe 2 and channel 511 there is no issue. I was under the impression that with the alphaPix 3, output 2 can start at universe 3 and Channel 1021(340x3=1020+1=1021) still confused. Appreciate help


Reply
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

It can, but that is with 340 pixels attached. You put universe 3 channel 751. It worked on universes of 510 channels. Universe 1 channel 1 through 510, universe 2 channels 1 through 510 and so on. It doesn't recognize channel 751. In absolute channel counts that's correct but the controller doesn't recognize it that way. Absolute channel 751 is universe 2 channel 241 and is what the controller recognizes.
The 2 universes per output is a board limit if you will. It won't control more than that amount. You can attach any amount you want up to that amount..... but, you have to let it know what you have attached in a form that it recognizes. I hope this helps and don't confuse you.


Reply
Page 1 / 3
Share: