Addressing multiple...
 
Notifications
Clear all

Addressing multiple E68x controllers

6 Posts
3 Users
0 Reactions
3,224 Views
jaywalk101
Posts: 761
Topic starter
(@jaywalk101)
Prominent Member
Joined: 15 years ago
[#20120]

Hey everyone,

Gotta quick question (or maybe not... 🙂 ). I haven't tested this out yet (waiting on two e681 kits to arrive), but wanted to see how other folks are addressing multiple universes. I'm going to be using 3 e681 controllers this year in my display. My first board will be using all four universes consisting of 1920 channels (Mega Tree). I have tested this and it works fine. I plan on using two other e681 boards for various other things in my display (pixel roof, arches, etc). Do I keep adding universes within the one instance of the J1sys E1.31 plugin in Vixen, or would it be OK for me to add another instance of the J1sys plugin for each E681 Controller? If I setup three different E1.31 plugins, can I keep the default Universe settings on each controller? The reason I'm asking this is that I had to re-arrange my channel count within Vixen and I had to skip 12 channels within one of my allocated universes.. Hopefully someone can read this and make sense in what i'm asking... Appreciate any advice or recommendations...

David


5 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Assuming you are using multicast then you need to change the universe numbers in the other controllers if I understood your question correctly.


Reply
chelmuth
Posts: 1077
(@chelmuth)
Noble Member
Joined: 16 years ago

Also there is no need to setup seperate plugins for each controller just add new universes to the existing plugin. and I belive inside the plugin you can set the start channel and number of channels that you are utilizing in each universe.. example universe 1 starts at 1 and has 128 channels universe 2 starts at 140 and has 200 channels which would effectively skip 12 channels.. hope that's kinda what you were looking towards.


Reply
jaywalk101
Posts: 761
Topic starter
(@jaywalk101)
Prominent Member
Joined: 15 years ago
budude wrote:Assuming you are using multicast then you need to change the universe numbers in the other controllers if I understood your question correctly.

I
Yes, I'm using multicast. But as far as using multiple instances of the J1sys E1.31 vixen plugin to address each controller, that should be OK as long as I assign a unique Universe number, right?


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
jaywalk101 wrote:I
Yes, I'm using multicast. But as far as using multiple instances of the J1sys E1.31 vixen plugin to address each controller, that should be OK as long as I assign a unique Universe number, right?

I did use separate instances for each controller (RPM's E1.31 bridge and an E681) last year because I thought I had to - in fact I had one for each universe - it worked fine - but I don't think this is necessary as others just run the single plug-in - just some ignorance on my end. It was easier to wrap my head around the settings using separate plug-ins but may have added additional overhead that I got away with because I didn't have much going on. This year though I will have five E681's and possibly RPM's bridge again so mucho universe's floating around...


Reply
Page 1 / 2
Share: