Additional Controll...
 
Notifications
Clear all

Additional Controllers?

9 Posts
6 Users
0 Reactions
3,492 Views
Posts: 99
Topic starter
(@kingjesse2)
Estimable Member
Joined: 11 years ago
[#54222]

Hi!

Right now I have some pixels around my house, but I want to use more. I asked for some opinions on where to put those in this forum (where you can also see what my house looks like).

No matter where I put my extra pixels (definitely thinking about doing something on the roof, whether it be lines of pixels or snowflakes), I will need a way to control them. My house right now is using a bunch of older LOR controllers, and the mega tree is controlled by a Falcon F16V3, only using 4 of the outputs. The Falcon is right below the mega tree in my yard, and it is connected to a network switch near my front door.

My question is:
What's the recommended way to control pixels that are further away from the Falcon? I know there is a falcon expansion board that can connect using ethernet, but I also know there are things like ESPixelSticks that I could buy and use on the roof as well. I don't just want to do the cheapest way, I want to do it a good way. Is it better to use the Falcon for everything or no?

Thanks!


8 Replies
Posts: 344
 TSL
(@tsl)
Reputable Member
Joined: 10 years ago

There is the expansion board for the Falcon to control differential recievers which can be, if I remember correctly, up to 250’ away from the f16. You may want to look into that. I use this set up and a Falcon F 48 fir distant items in my display.

Sent from my iPhone using Tapatalk


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

I have used a Falcon with differential receiver boards in the past and they work great, if you can easily run the cabling to connect them.

I tried ESPixelSticks last year, but I ran into too much lag for my liking, although I understand the newest version with SD cards on board eliminate this issue.

This year I have moved to several Raspberry Pi's with capes or hats in a Master/Remote setup to run separate sections of my display. Like the new PixelSticks these have the needed portion of the sequence stored locally on an SD card and only use wifi for an intermittent timing signal to keep everything in sync. Most of my new controllers are using the inexpensive Pi Zero with a hat. Each of these controllers has 2 outputs and cost less than $20 to build.


Reply
Posts: 401
(@kensington)
Reputable Member
Joined: 11 years ago

I run a combination of F16v3, F48, and several KulpLights controllers. I’m seriously digging the Kulp controllers for remote locations and wireless connectivity. Put them in “remote” mode (they run on FPP), and enjoy low network traffic.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I use multiple F16s spread around my property. Even then there are some long runs between controller and first pixel. There I use a few RobG pixel buffers and everything works fine.

Personally I have avoided using a Wireless network to transport real time lighting data. My show uses wired connections to all controllers. WiFi was designed as a "Best Effort" transport mechanism and does a less than stellar job in lighting (I know you can tweak and tune and make it work, but its a bother). This year I AM adding some ESPs to my show using the new V4 software that runs as a remote FPP with minimal network traffic.


Reply
Page 1 / 2
Share: