Adding a Single Nul...
 
Notifications
Clear all

Adding a Single Null Pixel on the F16v2

4 Posts
2 Users
0 Reactions
1,699 Views
relic1882
Posts: 104
Topic starter
(@relic1882)
Estimable Member
Joined: 12 years ago
[#43814]

I'm ecstatic to say that I finally have all of my lights working! It looks amazing! Man, I love pixels! I have one tiny issue that I'd love to figure out, but I can't grasp it or find the tutorial I need.

I have a string of pixels going all through my front porch area that is 278 pixels long. Vixen is already setup and functioning perfectly with my sequences and my universes and strings are all setup on the F16v2 and it's all working 99.9%.

At 151 pixels in on my porch area, I had to run a lengthy line, (well, only about 12 feet), from the bay window to the start of a railing off to the side, and I had trouble with the railing with flickering and not all the pixels were working. My voltage test good at the end of the strand so I knew it wasn't that. I added a pixel half way between the window and the railing. Bam. Problem solved. Everything to the end of that strand is working. But I think adding the pixel is goofing my channels because now at the end of my line of trees I have one that isn't doing anything.

How do I make that pixel I added to the wire stop lighting and become a Null? I don't really understand how to do it in the middle of a string on the Falcon controller. I tried splitting line up with virtual strings and putting a null number in place a few different ways but it keeps lighting anyway. Can someone help me with my last issue?

BTW, Thanks again everyone for helping me out. And thanks David Pitts for helping me out on the phone and on PMs. You guys are awesome!:cwaniak:


3 Replies
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

The F16v2 supports something called a virtual string. Break your string configuration into two parts (press the plus sign on the left side of the table next to your port). Assign the number of pixels for each part on either side of the null pixel. For the 2nd part, define a NULL pixel (far right side of the table). That will cause the single pixel to remain dark.


Reply
relic1882
Posts: 104
Topic starter
(@relic1882)
Estimable Member
Joined: 12 years ago
MartinMueller2003 wrote:The F16v2 supports something called a virtual string. Break your string configuration into two parts (press the plus sign on the left side of the table next to your port). Assign the number of pixels for each part on either side of the null pixel. For the 2nd part, define a NULL pixel (far right side of the table). That will cause the single pixel to remain dark.

If I do exactly that, the last pixel on my window is dark instead of the one in the middle of the line. Do I have to add an extra pixel in the first section under pixel count? If I do that, my channel number goes up past where my next string's channel begins. Will this be ok?


Reply
relic1882
Posts: 104
Topic starter
(@relic1882)
Estimable Member
Joined: 12 years ago

Got it to work. I had to add an extra pixel count to the first half and set null to 1. It seems to be good now. Thanks again!


Reply
Share: