What is the max number of pixels per output on the 6804 and 682?
On the 6804, I had a matrix of 300 pixels and the last 2 lines (60 pixels) wouldn't light. I had to run the data line from the second to last line to another output of the controller to get the last two lines to work.
This was asked elsewhere a while back - don't recall the number but it will vary on the pixel type/speed, etc. However I think 300 is too many for any type...
In theory 999 per output. That is way too many and way too slow. I have had no issues getting 450-600 working before. I would be checking your setup and injection, you will have to do power injection to get 300 pixels on a single output. Maybe post a pick of your controller set up and a sketch of how you are injecting power to try to see what is wrong
540 pixels will still give you a 50Msec timing on any one output. And as mentioned, you will definitely needing power injection...
I have 180 pixels / window x 3 windows (PI at each window) and 540 is working just fine.... thats a little over 3 full universes...
I have setup my e6804 with 375 pixels per output. In testing things look fine. I have 5 rows of 75 pixels zigzagged. I am injecting between strings 2 & 3, 4 & 5. I tested voltage at the end of the string and it shows 4.98v
habbo - what voltage do you have at the beginning of the string that you are able to still have 4.98 at the end? I'm running 5v 2812's with 5Vat the beginning of the string and there is almost a 1v drop after 30 pixels.
At 10 rows of 30 pixels, I am injecting power at the beginning of each row. Same power source, but injected at each row. Data I was just injecting at the beginning, but I wasn't able to get the last 60 pixels to light. I split it at 240, put the last 60 pixels on a separate output of the controller and they work fine.
Are you using DMX addressing, if so. Then the max addressable pixels is 170 or 510 channels. This is to prevent pixels bridging universes.
intwoit2002 wrote:Are you using DMX addressing, if so. Then the max addressable pixels is 170 or 510 channels. This is to prevent pixels bridging universes.
Are you sure? I thought you could span multiple universes -- even on single output. I don't think the the controller cares.
You maybe correct. I am going by something that Jim at San Devices said early on about the spanning of universes. He would be the one that really knows.
intwoit2002 wrote:Are you using DMX addressing, if so. Then the max addressable pixels is 170 or 510 channels. This is to prevent pixels bridging universes.
This is not true when using the Sandevices E68x series controllers, yes you can span universes using them. I am sure other controllers can as well.

