What is the normal operating range of 12 volt pixels? In other words what is the least voltage I can have at the end of a strand and still expect the nodes to function properly?
It depends on the quality of the pixels. The only 12v pixels I have are 3:1 stips. They seem to work up to 12.5v and down to 10.5v
Thanks Martin these are 12 volt nodes purchased last year from the diyledexpress presale.
As martin said, it really depends on the pixel. There's several different designs out there. I have some running a hair below 8v. Others peter off at 10 or so. It's a function of how the voltage gets dropped to what the pixels need. All LEDs have an inherent voltage of around 2-7-3.8V depending on color. Some pixels drop the voltage by using a voltage regulator. In this case you should be able to drop to almost 6 or 7 volts before seeing any issues. In fact, running this type as close to that dropout threshold as possible is the most efficient way to run them.
Others use some other simple circuit type and the behavior varies widely.
Pixels with multiple LEDs typically drive the group of LEDs in series to share the 12V across multiple pixels. If you have a pixel with 3 LEDs per pixel, and the highest forward voltage is 3.5v, you have 3.5 X 3 = 10.5.
Dkelly0802 wrote:Thanks Martin these are 12 volt nodes purchased last year from the diyledexpress presale.
I did some analysis on the 12 volt bullet pixels from DIYLedExpress. The circuit board for these pixels includes an LM7805 voltage regulator that drops the input voltage down to 5V to serve as the voltage rail for the ws2811 chip and the RGB LED. The dropout voltage for the regulator is around 2 volts, so as long as the supply voltage is above 7 volts the pixel should function correctly.
The max voltage for the 7805 is actually around 25 volts, so you could *almost* say that the 12 volt DIYLE pixels are actually 7-25V pixels. Unfortunately, there is a slight issue with the input capacitor for the 7805 in that the voltage rating for this capacitor is unknown, so if you actually run the pixels at say 24 volts there is a strong possibility that the you will blow that cap. I suspect that cap is rated for 16 volts, but there is no way to determine that from the circuit alone.
