I need to get pic's programmed with PWM to run LED's and I could use some help.
I have a pic programmer, cheap ebay clone and WinPic800 software in some language I do not understand. I was able to clone a non-PWM chip for all of my boxes last year, but I do not have any PWM to clone.
How do I get the .ASM -> .HEX and then get it loaded. I must say that when I tried to load a .HEX last year I never got a good burn for some reason.
Is there some software I can download in English instead of WinPic800? Do I need an assembler to create the .HEX?
Another option is if I could get a PWM chip that I can clone.
- Michael
Yes, you need software to assemble the .asm to get the .hex.
You can download the MPLAB software from Microchip and use it.
http://ww1.microchip.com/downloads/en/DeviceDoc/mp810.zip
User guides at the bottom of this page..........
http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1406&dDocName=en019469&part=SW007002
I found this when I was using WinPic:
Comments from Firegod in the Firegod forum on DIYC…
The only problem with Winpic800 is that it installs in Spanish but after selecting the menu item "Idioma" and changing it to English, it is quite easy to use.
Thank you both for the replys, it is exactly what I need to get this done.
- Michael
I Did It, I have Blinky Flash for LED's !!!!!
Thank you for the help and directions, it was exactly what I needed to get it done. Now I can program all the pic's I need.
I can probably program them for others that need some also.
- Michael
