Programming PICs Pr...
 
Notifications
Clear all

Programming PICs Problem

16 Posts
7 Users
0 Reactions
14 K Views
Posts: 360
Topic starter
(@jlstout)
Reputable Member
Joined: 16 years ago

I don't see 16F688 on device list in pickit 2.


Reply
Posts: 451
(@utimgr)
Honorable Member
Joined: 14 years ago

It can be problematic powering the device from the programmer. I haven't used my pickit2 or 3 for a while, I use a ICD3 and even then, it can be hit or miss. Is there an issue of powering up the target for programming it?


Reply
Posts: 360
Topic starter
(@jlstout)
Reputable Member
Joined: 16 years ago

Also keep getting VPP voltage error. This error pops up in the MPLab IDE software also. Could I have bad pics? Bad pickit 2? Really stumped here.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

It could be your com port , be sure your using a usb2 port and that the port is open .


Reply
beeiilll
Posts: 869
(@beeiilll)
Prominent Member
Joined: 19 years ago

I don't have a Renard but from the Wiki it looks like a 16F688 is the pic for it.

Did you go through the ICP02V2 PDF file to set it up by chance? Great source and how I set mine up. There is a file called PK2DeviceFile.dat that you have to install after getting the software at http://www.piccircuit.com/ins/PICkit2v2.61.zip . That will give you the 16F688 pic and more on the device list. The pdf manual is available from your first post link for the programmer if you need it. Down at the bottom of the page for the programmer there are links.

I found that using the MPASMWIN software for making hex files is so much easier than trying to learn the MPLab software. The WIN program is part of the MPLab program. If you go to the file folder for MPLAB, then to the folder for MPASM Suite, and you will find the MPASMWIN.exe file. Just make a shortcut on your desktop for it and it will run.

The VPP error I got on mine till I set it to 5.0 in the PICKit 2 software as well. Possible to have a bad pic or programmer or it could be something with computer communicating with the programmer.
I am by no means very well versed with the programmer as I just got mine and programmed a bunch of the 16F688 pics for some FAST snowfall tubes.

I would say check the pdf manual for the programmer and see what pops up since you say that you don't "see" the 16F688 in the list, that is certainly a start point to me. Make sure that the .dat file is installed so that you see it when you look at the Device: Select Part listing.

My PICKit is running Version 2.61.00 by the way.


Reply
Page 2 / 4
Share: