Notifications
Clear all
Nov 11, 2009 6:14 pm
iv got the ren64 vXB and the U1 trace pads are gone so i have build an external board tied to U2, the external board contains the 5v reg and 1000uf cap.
my clock is cooked and i have tried the diagnostic firmware with the internal clock and im no longer getting a zero crossing signal.
im bring the zero crossing on J1 thru a opto at 12vac(thru 2.5k resistance)
my thought on this is that i may have blown the opto aswell.
anyone have a link to the old old version of the firmware with out the zero crossing signal and internal clock only?
1 Reply
Nov 11, 2009 7:12 pm
just tried to connect a max232 to the serial inputs to see if i could get the signal input light to blink on the diagnostic firmware with no luck
