I must be doing som...
 
Notifications
Clear all

I must be doing something wrong - Programming PIC for Renard24LV board

2 Posts
2 Users
0 Reactions
1,741 Views
macebobo
Posts: 1595
Guest
Topic starter
(@macebobo)
Member
Joined: 17 years ago
[#21826]

I am trying to set the start address of my Renard 24LV (V2) board and have configured the Renard-20090915.asm file with the following...


<snip>

;; PWM_build can be either 0 or 1
#define PWM_build 1
;; DC_build can be either 0 or 1 (it should be 0 if PWM_build is 0)
#define DC_build 0

 #define CLOCKRATE 18432000
 #define BAUDRATE 57600

;; START_ADDR should normally be 0.  It is changed to another value if you
;; wish for the particular PIC to ignore a certain number of (8-byte) records
;; at the start of a frame (for wireless operation, mostly).
	
 #define START_ADDR 9

;; CTR_LOCKOUT should be 1 for the DC build, can be a somewhat larger number
;; for non-PWM or non-DC builds.

 #define CTR_LOCKOUT 15

;; For positive_true outputs, remove the following define (normally, this
;; should be left in place).
;; #define OUTPUT_NEGATIVE_TRUE

<snip>

I want to use positive output, 57600 baud, start this controller on channel 73 and use PWM. I flashed the pic, but it does not respond on any channel. I reflashed the pic back to the original FW and it responds on channel 1 as expected. Am I missing a configuration option? If not, could someone send me the hex file that should work?

Thanks,
John


1 Reply
macebobo
Posts: 1595
Guest
Topic starter
(@macebobo)
Member
Joined: 17 years ago

Nevermind, had to change DC_build to 1 and CTR_LOCKOUT to 1, too.

-- John


Reply
Share: