So the ren48lsd as well as ssr drivers like the ren64 put out common +voltage and then use negative voltage for each channel (the opposite of what robG's LED board wants). The pics in the ren48 are signaling with +voltage but driving transistors that in turn put out negative signal. What you want is the firmware of the ren48lsd but without a transistor in the way. Also, since robG's boards default on, you'd want firmware that flips the received dimming level around (255-value) so a max bright value of 255 would result in no output and leave the board on.
Seems like we need a new Renard board to drive these LED drivers. Hopefully one of the smart guys out there got a big batch of these LEDs and decide to design a board and share their work! 😀
Edit: I'm certainly not the smart guy. I can't even spell right on the first try! 😉
thuddman wrote:So the ren48lsd as well as ssr drivers like the ren64 put out common +voltage and then use negative voltage for each channel (the opposite of what robG's LED board wants). The pics in the ren48 are signaling with +voltage but driving transistors that in turn put out negative signal. What you want is the firmware of the ren48lsd but without a transistor in the way. Also, since robG's boards default on, you'd want firmware that flips the received dimming level around (255-value) so a max bright value of 255 would result in no output and leave the board on.Seems like we need a new Renard board to drive these LED drivers. Hopefully one of the smart guys out there got a big batch of these LEDs and decide to design a board and share their work! 😀
Edit: I'm certainly not the smart guy. I can't even spell right on the first try! 😉
Yes I think that was one of the first things Brian said to me, if it has not been built you can skip the transistors 🙂
Tory
Yep, you can skip the transistors. Just make sure you don't exceed the current capacity of the PIC. I don't remember what the max is from the 16F688, you would need to check the data sheet.
dvc2013 wrote:Yep, you can skip the transistors. Just make sure you don't exceed the current capacity of the PIC. I don't remember what the max is from the 16F688, you would need to check the data sheet.
I believe it's 90mA total for the chip or ~9-10mA per output - I don't know what is required from the 10W board. You're probably right dvc - I'm trying to think of the circuit in my head but it may not work as-is - no harm in trying however.
Wont the common pins (1,3,5,7) still be positive? I suppose you could rig up an interesting adapter cable and tie those to V IN-.
