Changing renard pic...
 
Notifications
Clear all

Changing renard pic code issues

37 Posts
7 Users
0 Reactions
26.8 K Views
will3ishere
Posts: 327
Topic starter
(@will3ishere)
Reputable Member
Joined: 18 years ago

I will give that a shot this evening, I have not been shuting the computer off and back on after making the change to 115200


Reply
will3ishere
Posts: 327
Topic starter
(@will3ishere)
Reputable Member
Joined: 18 years ago

So after making the necessary changes to baud rate and then shutting computer down, still no flash. I right clicked on the
.HEX file and saved it to my directory on the c drive. Just for giggles i cleared the pickit2 programm and flashed the chip
and yes channel one came on as you said it would if the pic is blank, any time i have the firmware that is supposed
to be 115200 it just does nothing


Reply
Posts: 2215
(@ctmal)
Famed Member
Joined: 19 years ago
will3ishere wrote:So after making the necessary changes to baud rate and then shutting computer down, still no flash. I right clicked on the
.HEX file and saved it to my directory on the c drive. Just for giggles i cleared the pickit2 programm and flashed the chip
and yes channel one came on as you said it would if the pic is blank, any time i have the firmware that is supposed
to be 115200 it just does nothing

So, after you flash the pic with the 115200 you get absolutely nothing, correct? Including no channel 1?
What happens if you set Vixen and the device manager settings back to 57600 with the 115200 code on the pics?

Also, I keep noticing that you are saying you are flashing the pic, not pics. I believe you said you had a 24 channel renard, correct? You need to flash all 3 pics.


Reply
Posts: 2215
(@ctmal)
Famed Member
Joined: 19 years ago

My next suggestion would be to download the diagnostic firmware. You can change the baud rate in that using the same method as the operational firmware. That should point in the right direction as to what is going on.


Reply
Reddy_Kilowatt
Posts: 547
(@reddy-kilowatt)
Honorable Member
Joined: 19 years ago

Just a thought... not all serial converters (even ones that claim to) work at 115200.

-Craig


Reply
Page 7 / 8
Share: