So i can download a copy of the firmware from the wiki, compile it and then burn it to a chip.
it will work, but when i make a change and try to compile it and then burn it i get no
communication from vixen to my renard controller. When i make the change i am coping the file
from the internet, pasting in note pad, making my changes, then saving it to the folder i created, as an .ASM file.
before i do all this, i made sure to clean out the created folder before continuing. Puzzled
What changes are you trying to make?
PWM 1 and baud rate to 115200
Sent from my iPhone using Tapatalk
if i copy from the wiki the operational firmware, then paste into note pad, make the changes to the firmware, then save as an .ASM file to my directory
it will not work. If i save file directly to my directory it works just fine? Any ideas on what i am doing wrong
most likely something doesn't copy paste right
will3ishere wrote:if i copy from the wiki the operational firmware, then paste into note pad, make the changes to the firmware, then save as an .ASM file to my directory
it will not work. If i save file directly to my directory it works just fine? Any ideas on what i am doing wrong
