PrimoPDF heads up
 
Notifications
Clear all

PrimoPDF heads up

5 Posts
4 Users
0 Reactions
4,395 Views
Posts: 2216
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago
[#7259]

Just wanted to give a heads up in case anyone else is doing things this way.
I was creating a board in expressPCB and printing it to a pdf file using PrimoPDF. I was planning on using the pdf file to print on a laser printer and self etch the board.
Here's the issue...it seems when you use PrimoPDF it changes the layout a bit. Everything seemed to have been shrunk just enough so that the holes for ic's, rj45's, etc. do not line up with the real life parts. Printing directly to the printer without PrimoPDF works fine though.


4 Replies
Posts: 919
(@scorpia)
Noble Member
Joined: 19 years ago

check that its not the printer resizing the pdf to fit the page. usually i find that adobe reader has the default set to fit to page in the printing options.

Peter


Reply
omzig
Posts: 1603
(@omzig)
Noble Member
Joined: 19 years ago

That may be the problem, but when I was having some unrelated problems with Primo, I seem to remember reading about some sizing issues too. I can't seem to find the references to them now though.

I switched to Bullzip and it has been working well so far.


Reply
pete
Posts: 562
 pete
(@pete)
Honorable Member
Joined: 20 years ago

I've printed directly from ExpressPCB? Are you trying to save the file to bring to a laser printer?


Reply
Posts: 2216
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago

I reinstalled everything and now it seems to be working but I just wanted to give the heads up that if you are printing using PrimoPDF you'll probably want to check that everything lines up correctly before you try and etch it.
The origional reason for printing to pdf is so that I can save the files on my website.

Thanks for the input.
Chris


Reply
Share: