PCB Prototypes
 
Notifications
Clear all

PCB Prototypes

16 Posts
10 Users
0 Reactions
29.2 K Views
mndless
Posts: 163
Topic starter
(@mndless)
Estimable Member
Joined: 14 years ago
[#30743]

Have been using Elecrow for a while, have no complaints... other than the 4 week turn around, or so...

And that is in no way an enditement of Elecrow.. the fact that they can turn out boards within a week and get them shipped is impressive. Simple fact is, it then takes several weeks to get the boards delivered.

So... for those cases where you really need something quickly, is there a fast state side service anyone would recommend?? for small batch prototypes ???

Just had a board design failure... haven't yet sorted out the issue, but would really like to not wait another 4 weeks to get the next batch.... I know small batches state side is probably going to be a hurdle... but, any suggestions would be appreciated.

Muchos Gracias


15 Replies
Posts: 2168
(@djulien)
Noble Member
Joined: 19 years ago
mndless wrote:So... for those cases where you really need something quickly, is there a fast state side service anyone would recommend?? for small batch prototypes ???

ExpressPCB isn't the cheapest, but their mini-board prototype service isn't too expensive if your design will fit within their pre-determined size. You can get boards back from them in less than a week and they are good quality. Their software is proprietary, but easy to learn. There is also a way to get Gerbers out of it if you want to switch to another vendor after prototyping.

Oshpark is also good. They take a little longer than ExpressPCB (but not much), and they don't have the board size restrictions like the ExpressPCB mini-board service.

don


Reply
mndless
Posts: 163
Topic starter
(@mndless)
Estimable Member
Joined: 14 years ago

Thanks Don... will check those out


Reply
Posts: 1133
(@toozie21)
Noble Member
Joined: 19 years ago
Reply
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

WOW,
10 boards for 10 bucks ! 5cm x 5cm

toozie21 wrote:I haven't used them yet, but one I bookmarked was: http://smart-prototyping.com/Prototyping-Services/Electronic-Prototyping

Reply
Page 1 / 4
Share: