PSU Loading Calcula...
 
Notifications
Clear all

PSU Loading Calculations

6 Posts
5 Users
0 Reactions
2,303 Views
Posts: 11
Topic starter
(@mcconnellhaus)
Active Member
Joined: 5 years ago
[#55495]

Hey, When you guys are calculating your loading on your power supplies, do you do it at show brightness (I've seen 30% here) or do you calculate at 100% brightness on white?

I was thinking of 30% brightness on white (.06A x 30% = 0.018A per node)

Cheers!
Jer


5 Replies
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

You can calculate it at the percent of brightness. I wouldn't go less than 50% when doing calculations. Also, don't load the PSU past 80% for a safety margin. Better to overbuild than hurt a piece of equipment.


Reply
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

I use full bright white (.06a) per pixel for my calculations. Others use a percentage. I have not had a power supply failure yet.

I switched my denser props to 5v pixels so I could run more pixels per supply.


Reply
Posts: 418
(@richienorthcott)
Reputable Member
Joined: 7 years ago

One think worth checking is the 'power on state' for your pixels - I know for my 12V pixels they come 'on' (full white) when I power up the controller, once the controller is initialised they switch off (i.e. they start receiving zeros in the WD2811 data)

This may / may not be an issue depending on the controller / pixels you have

I run mine at about 40% max normally, I do this using dimming curves in Vixen since my controllers are very basic, though I think some controllers also offer this function i.e. modifying the received data to lower intensity before sending on to pixels (I guess by multiplying bytes values by a % brightness)


Reply
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

An example of why to use full bright white for design purposes would be if you have a problem with a string, say water got into a connection causing the pixels to light without a control signal. They could come on full bight white, or other full bright color, and draw closer to max currents. Yes, this has happened to me where water got into a connector and into a splice.
If you think about it, regardless of setting your brightness to 30% or so, you still have to run a lot of channels from your controller or provide power injection. The only thing you save is the cost of addition power supplies and maybe enclosures at the risk of spending a lot more time to repair/replace failed components operating at the edge of their capabilities. Power supplies usually run less than $25 (except Meanwell) and enclosures can be inexpensive too.


Reply
Page 1 / 2
Share: