I just want to be sure I did this correctly. I had all the white channels on my Mighty Mini's burn out last year. I just found all the bad LEDs and pulled them while waiting on the replacement parts. When I measured the voltage drop between LEDs I could see clearly that it was no where near the 3.4 v forward voltage the is on CeCe's website. The values were closer to 2.5 V consumed between LEDs vs. the 3.4 on the website.
What I did is put my Multimeter in DC voltage mode and measured from the power input negative to each LED lead. I found the difference between the voltage between either side of the LED. Is this the "forward voltage"?? If so then the 2.5 takes me closer to a 100 Ohm resistor vs. the 47 that is in there, and seemingly explains the channel burnout.
Am I doing this correctly?
To do this properly, you should have a constant current source and then measure the voltage across the LED. Normally the white LEDs are in the 3.2(ish) area (specs are typically 3.0 to 3.4) - 2.5v sounds too low to me.
Based on what you are saying the test is correct. 2.5 is the average and low, (some are 2.7 and others 2.2) but the test is working on the RGB channels and they are in tolerance to the spec. AND they did not burn out. I'm wondering if the website is correct.
2.5 seems EXTREMELY low for a white LED at normal drive currents.
How much current was going through the LED when you measured it? At extremely low currents (but still enough to light), it might only be 2.5 volts. You need to measure at rated drive current (100 mA).
Another way to check - When the unit is fully powered up, measure the drop across your current limiting resistor and calculate the current that way. If it's above 100 mA, you're overdriving the LEDs. Personally I'd derate to 80 mA for safety, those 5-chip units don't exactly have the best heatsinking.
budude wrote:To do this properly, you should have a constant current source and then measure the voltage across the LED.
You could also temporarily assume that the voltage drop is zero and calculate a resistor. Use this to measure the actual voltage drop, and then calculate the correct resistor.
