LED Strobe Control
 
Notifications
Clear all

LED Strobe Control

2 Posts
2 Users
0 Reactions
2,004 Views
mattrob
Posts: 136
Topic starter
(@mattrob)
Estimable Member
Joined: 18 years ago
[#14041]

I'm in the process of planning my 2011 display. I want to add LED strobes and have been reading up on the strobes from the 2010 coop. I've read some posts and seen pictures about the construction (surface-mount soldering looks challenging), but I haven't seen much on the wiring and control aspect. How did everyone control their strobes? Low-Voltage Renard or DC SSR?


1 Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

I hard-wired the trigger signal and just ran +5v/Gnd back to a Ren48LSD. I put modified versions of the code on groups of PICs and then spread them out in the display. I just enable the channel and that turns on the voltage to the strobe - worked great for me anyway. The other method involves using 3-wires - +5v, Gnd, Trigger but I didn't want to mess with the extra wire for each strobe.

Worst case they draw a bit over 100mA each when fully on so account for that if you put multiples of them on the same channel.


Reply
Share: