E682 cat5 connector...
 
Notifications
Clear all

E682 cat5 connector problem

4 Posts
3 Users
0 Reactions
1,807 Views
Posts: 825
 DanJ
Topic starter
(@danj)
Prominent Member
Joined: 13 years ago
[#34864]

I am running two E682s this year. I am having trouble with one controller's cat5 connector. The connector on the E682 intermittently doesn't make good connection with the cat5 male end; of course that stops the controller dead in its tracks. I was able to barely touch the top of the connector and get it to work most times, but not all times. Not throwing E682 under the bus here (mine worked great last year and continues to work great this year... easy to setup & use)... Just wanted to see if anyone else has experienced this and could give me an idea how to resolve it so it is no longer an intermittent problem. Thanks in advance.


3 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

If your wiznet is socketed remove it and gingerly spread it's pins so it fits snug 🙂

when you re install you kinda want to roll it in slightly

align 1 complete side first and in a rolling motion fit in the other side .

this will help reduce the stress from the rj45 module once inserted .


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago

Look inside the rj45 jack and make sure the pins are straight and at the proper height. They sometimes can get bent.


Reply
Posts: 825
 DanJ
Topic starter
(@danj)
Prominent Member
Joined: 13 years ago

Thanks so much for the advice. I was thinking today that it is probably as simple as making sure the pins inside the female connector are "reaching out" appropriately...
I appreciate the responses!


Reply
Share: